File timing.txt artifact 4d5b1bcab4 part of check-in 484f1837b4



    This file is part of GRG 3.2
    Copyright (C) 1997-2000 Vadim V. Zhytnikov

    GRG 3.2 and REDUCE Timing

Here I collected some statistics on the performance of REDUCE and
GRG 3.2 on various platforms. This information can be useful if you
want to estimate which type of machine you need for your problems.

The statistics includes timing for three different tests:

1. First time T1 is the run-time of the standard REDUCE test reduce.tst.
   To run this test you have to start REDUCE and type the command
     in "$reduce/xmpl/reduce.tst";

2. Second test T2 is the computation of the irreducible curvature
   spinors for the Bondi metric. This metric is widely used for
   comparing performance of computer algebra systems in general
   relativity. To run this test you have to start REDUCE and GRG
   and enter the command
     "bondi.up";
   or
     "bondi.low";
   You must use "bondi.up"; if after start GRG prints
      System variables are upper-cased: E I PI SIN ...
   and "bondi.low"; if the message reads
      System variables are lower-cased: e i pi sin ...

   The output of this test is stored automatically into the file
   bondi.out and the timing can be found at the end of this file:
     Time: XX.XX sec (Y%GC)

3. Two previous tests run quite fast on modern computers and their
   typical run-time is just several seconds. Thus they do not reflect
   properly the performance for really hard computations. The third
   test is a more complicated task which usually runs many minutes
   and requires 8Mb of RAM or more. This test computes field equations
   for some exact solution of the Poincare Gauge Theory of Gravitation
   with dynamical torsion. To run this test you have to start GRG
   and type
     "pgt.up";
   or
     "pgt.low";
   as explained above. Type quit; to terminate GRG session.

All timings below are given in seconds. The GRG timings T2 and T3 are
given including the garbage collection time and the garbage collection
percentage is shown in parentheses.

------------------------------------------------------------------------------
Machine and OS:                     REDUCE:      T1:      T2:       T3:
------------------------------------------------------------------------------

  Notebooks i86:
Cx486DX 33MHz (DOS)                3.4 PSL 7Mb   5.2   15.0 (3%)  2911.5 (19%)
Cx486DX 33MHz (DOS)                3.5 PSL 7Mb   5.7   27.4 (2%)  5216.1 (14%)
Cx486DX 33MHz (DOS)                3.6 PSL 7Mb   6.0   26.0 (2%)  3933.3 (11%)

  PC i86:
386DX  40MHz (DOS)                 3.4 PSL 3Mb   9.0   27.6 (1%)
486DX2 66MHz (DOS)                 3.4 CSL 10Mb  5.8   27.8 (0%)  5174.9  (8%)
486DX2 66MHz (DOS)                 3.5 PSL 8Mb   2.9   13.2 (3%)  2605.0 (12%)
486DX2 66MHz (Win3.1)              3.5 PSL 15Mb  3.5   13.0 (0%)  2389.7  (5%)
486DX2 66MHz (DOS)                 3.4 PSL 18Mb  3.2    7.3 (0%)  1215.5  (7%)
486DX2 66MHz (DOS)                 3.6 PSL 18Mb  3.5   12.2 (0%)  1851.6  (3%)
Pentium 100MHz (DOS)               3.4 PSL 10Mb  1.3    3.5 (0%)   610.0 (10%)
Pentium 100MHz (DOS)               3.4 PSL 10Mb  0.77   2.1 (0%)   401.6 (13%)
Pentium 166MHz (DOS)               3.4 PSL 7Mb   0.66   1.6 (3%)   314.2 (21%)
Pentium MMX   166MHz (DOS)         3.4 PSL 8Mb   0.33   1.2 (4%)   226.3 (20%)
Pentium MMX   166MHz (DOS)         3.4 PSL 24Mb  0.33   1.1 (0%)   191.9  (6%)
Pentium MMX   233MHz (DOS)         3.4 PSL 48Mb  0.38   0.9 (0%)   145.3  (3%)
Pentium MMX   233MHz (DOS)         3.5 PSL 48Mb  0.28   1.6 (0%)   317.4  (1%)
Pentium MMX   233MHz (DOS)         3.6 PSL 48Mb  0.38   1.7 (0%)   251.7  (1%)
Pentium MMX   233MHz (Linux)       3.6 PSL 36Mb  0.39   1.6 (0%)   226.3  (1%)
Pentium Pro   200MHz 256Kb (DOS)   3.4 PSL 24Mb  0.31   0.8 (0%)   127.9  (5%)
Pentium Pro   200MHz 256Kb (DOS)   3.6 PSL 24Mb  0.49   1.3 (0%)   192.2  (2%)
Pentium II    233MHz (DOS)         3.4 PSL 48Mb  0.27   0.6 (0%)   109.1  (3%)
Pentium II    233MHz (DOS)         3.6 PSL 48Mb  0.44   1.3 (0%)   181.9  (1%)
Pentium II    233MHz (Linux)       3.6 PSL 36Mb  0.30   1.1 (0%)   136.4  (2%)
Pentium II    233MHz (Linux)       3.7 PSL 48Mb         1.3 (0%)   143.5  (1%)
Pentium II    266MHz (DOS)         3.4 PSL 48Mb  0.26   0.6 (0%)    96.2  (3%)
Pentium II    266MHz (DOS)         3.6 PSL 48Mb  0.34   1.1 (0%)   154.2  (1%)
K6-2          350MHz (DOS)         3.4 PSL 32Mb  0.5    0.8 (0%)   114.5  (4%)
K6-2          400MHz (DOS)         3.4 PSL 48Mb         0.6 (0%)   101.3  (3%)
K6-2          400MHz (DOS)         3.6 PSL 48Mb         0.9 (0%)   166.7  (1%)
Celeron A     366MHz (DOS)         3.4 PSL 48Mb  0.1    0.4 (0%)    70.2  (4%)
Celeron A     366MHz (DOS)         3.6 PSL 48Mb  0.2    0.8 (0%)   146.0  (1%)
Celeron A     366MHz (Linux)       3.6 PSL 48Mb  0.2    0.7 (0%)   110.3  (2%)
Celeron A     366MHz (Linux)       3.7 PSL 48Mb         0.9 (0%)   116.6  (1%)
Pentium II    450MHz (DOS)         3.4 PSL 36Mb  0.2    0.3 (0%)    62.1  (4%)
Pentium III   450MHz (DOS)         3.4 PSL 48Mb         0.6 (0%)    60.4  (4%)
Pentium III   450MHz (DOS)         3.6 PSL 48Mb         0.3 (0%)   101.5  (1%)
Celeron A     500MHz (DOS)         3.4 PSL 48Mb         0.4 (0%)    53.7  (4%)
Celeron A     500MHz (DOS)         3.6 PSL 48Mb         0.6 (0%)   118.9  (1%)
Celeron A     500MHz (Linux)       3.7 PSL 48Mb         0.6 (0%)    97.1  (1%)
Pentium III E 500MHz (DOS)         3.4 PSL 48Mb                     50.6  (5%)
Pentium III E 500MHz (DOS)         3.6 PSL 48Mb                     75.6  (2%)
Pentium III E 667MHz (DOS)         3.4 PSL 48Mb                     39.3  (6%)
Pentium III E 667MHz (DOS)         3.6 PSL 48Mb                     58.1  (2%)
Pentium III E 733MHz (DOS)         3.4 PSL 48Mb                     33.6  (4%)
Pentium III E 733MHz (Win98)       3.6 CSL/WC 48Mb                 156.0  (1%)
Pentium III E 733MHz (Win98)       3.6 CSL/VC 48Mb                  67.0  (2%)
Pentium III E 733MHz (DOS)         3.6 PSL 48Mb                     50.8  (1%)
Pentium III E 733MHz (Linux)       3.7 PSL 48Mb                     38.9  (2%)

  IBM RS/6000:
RS/6000 3BT  (AIX)                 3.5 PSL 8Mb   1.1    6.0 (5%)  1267.1 (15%)
RS/6000 590  (AIX)                 3.5 PSL 8Mb   1.1    5.9 (5%)  1226.8 (15%)

  SPARC:
SPARC 1+                     65MHz 3.6 PSL 20Mb  3.2   12.5 (0%)  1716.1  (5%)
SPARC 2                      75MHz 3.6 PSL 20Mb  2.1    7.8 (0%)  1132.2  (4%)
SPARC 10/20     SuperSPARC   33MHz 3.6 PSL 20Mb  1.4    5.9 (0%)   832.0  (3%)
SPARC 4         microSPARC  110MHz 3.6 PSL 20Mb  0.98   3.5 (0%)   442.0  (3%)
SPARC 20-612  2xSuperSPARC   60MHz 3.6 PSL 20Mb  0.76   3.2 (0%)   431.1  (4%)
HyperSPARC 22 2xHyperSPARC  125MHz 3.6 PSL 20Mb  0.58   2.3 (0%)   308.4  (4%)
Ultra 1         UltraSPARC  167MHz 3.6 PSL 20Mb  0.30   1.2 (0%)   187.9  (4%)
Ultra 2       2xUltraSPARC  167MHz 3.6 PSL 20Mb  0.31   1.2 (0%)   190.5  (4%)
Ultra 2       2xUltraSPARC  167MHz 3.7 PSL 120Mb                   299.0  (0%)
Ultra 4    4xUltraSPARC-II  400MHz 3.7 PSL 120Mb                   113.1  (0%)
Ultra 5/10   UltraSPARC-IIi 440MHz 3.7 PSL 120Mb                   114.6  (0%)

------------------------------------------------------------------------------


GRG for REDUCE
GRG Homepage | GitHub Mirror | SourceHut Mirror | NotABug Mirror | Chisel Mirror | Chisel RSS ]